CAR STEREO ACCESSORIES

Installation Accessories
Quite a multitude of accessories are available for your car stereo. Some of them are madatory such as RCA cables and others are elective like wiring harnesses.
RCA Cables:
RCA cables are needed to transfer pre-amp (line level) signals. Usually, you use this form of cable for unamplified signals such as the connection between your head unit and amp or crossovers/eqs. Its vital to find the correct thickness and shielding. The end connectors should be sturdy to prevent breakage from stress. There is a notion that more expensive the cable, better the sound quality. However do not spend more than $1/foot. You may need to spend more to get cables immune to noise if that is a problem in your car.
Speaker Cables:
When the line level signal from the head unit is amplified it becomes more powerful and requires thicker cable to carry it. This is even more pronounced for subwoofer wiring. Try to use between 7 gauge and 1415 gauge wiring for subwoofers, nothing smaller. A lot of current has to pass through those wires. For tweeters and midranges thickness is less critical but still important to prevent leakage and contamination from outside sources.
Power Distribution Blocks:
Power distribution blocks make wiring easier. You can run one thick power cable from the battery to the distribution block and from there you can use its multiple outputs for each component. A related item is a new battery terminal which allows easy connection of your extra power wire on the battery for the car stereo.
Capacitors:
Music is dynamic and its power requirements vary. Your car's electrical system may not be able to keep up with these surges in demand. A "stiffening" capacitor can solve this problem by providing more storage capacity for those high power transients.
Wiring Harnesses:
A wiring harness is for you if you plan to replace your factory head unit but still want to be able to reinstall it. These are specifically designed for each type of car and allow you to disconnect your stock radio and connect a new head unit without cutting your original wiring. The wiring harness plugs into your existing wiring and allows you to connect a new head unit to the harness.

By: Professor Apex

Professor Apex is an Guru In Car Stereo and Car Video. He has more than 12 years of experience. You can find him here: Wholesale'>www.apex-audio.com">Wholesale Car Audio.

Article Directory: http://www.articlewisdom.com

Please Rate this Article

5 out of 54 out of 53 out of 52 out of 51 out of 5 

Not yet Rated